POPPUMP Vatican City State Technical Center

Tel:(001)3474109611

POPPUMP logo

POPPUMP Vatican City State Technical Center , Discuss Technical Problem , Suply After Service Online of Fuel Dispenser, Please Regist Firstly

D-GA44 FUEL DISPENSER

D-GA44

D-GA44 FUEL DISPENSER

Pump Type: Optional

Inlet Pressure : >=54kPa.

Flow rate (L/min.) :55±5

Suction Distance (m): 6(verticalmente) / 50(orizzontalmente)

FlowMeter Type: Optional

Accuracy :±0.2%

Motor Voltage(V) :110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle : Auto Shut-off Nozzle

Environmental Condition : -40~~+55degree

Control Type: Solenold Vale Control Type

Preset : Function Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Optional Display :Type LCD and Bright Backlight

Digit of Volume : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price: 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Totalizer :1~~9,999,999

Hose :4.5m

Weight : 335kg

Dimension(L×W×H): 1270 x 620 x 2420(mm)

Dimension(L×W×H)Of Qty of Container: 40ft: 45 20ft: 22

products links

links

technical archives

    causing noise and abnormal vibration is many, either because of fuel dispenser�or exterior elements (pipe trouble). Therefore, it is first to exclude exterior reason of fuel dispenser, then interior one when overcome the above situation. After that, examine strainer and clean dirty. Next parts being ch fuel dispenser ecked is overflow valve. Tight spring will stick valve core and generate large noise and vibration. In addition, don’t pursue large flow rate through adjusting spring extensively, since that will shorten the service life of fuel dispenser due to large system pressure. If noise is still large after the above maintenance, pump should be disassembled so as to examine vane and spring whether broken. If these parts are broken the outlet flow fluctuation of pump would be enhanced, as well as noise and vibration. The solution method is to change a new vane and spring. Leakage Leakage is divided as two categories, namely, inner leakage and outer leakage. Under the high oil pressure in hydraulic system o fuel dispenser il is leak from high pressure area to low area, which is called inner leakage. The abrasion of vane, rotor and frame result in extensive inner leakage so as to reduce delivery volume of fuel dispenser. The outer leakage is the one oil leak from inner hydraulic system into outer, which increase unsafe environmental elements except from affecting the normal working performance of pump. To change a new oil seal when find a leakage coming from the root of pump axis. Be sure that don’t make a mistake in installing oil seal. Diagram 2-7 show the correct position ----- the labium of oil seal should face to inner chamber. In addition, tight V wheel also hurts the surface of oil seal next to pump axis so that its capacity is invalid. Diagram 2-7 The most leaking sections are the connecting face---- between pump cover and pump frame, between pump frame and vapor separator, place of cap nut of overflow valve. All of reasons are damaged seal loop or seal gasket, thus change new sealed components as soon as quickly. fuel dispenser

technical specification

    - - - 1   Open - - 3 - -   Close - - - 2 - 〠fuel dispenser € MAJOR ERROR 1 - 1 - 1 - 1   MINOR ERROR 1 2 3 100   (OTHER) - - - -  Description: N = No state change. - N = State change to n. - = Not applicable.  Version 2.00 IFSF - STANDARD FORECOURT PROTOCOL November 2004   CONTROLLER DEVICE APPLICATION   fuel dispenser Page: 9  2.2 State Event Description   THIS SECTION IS THE SAME FOR BOTH CD AND CDP.  2.2.1 State INOPERATIVE 1   STATE DESCRIPTION   INOPERATIVE The CD is in the INOPERATIVE state when it is not possible to function. The reason for   this is that essential operational data is missing or a major error has been detected. The CD is   also in the INOPERATIVE state after a system boot and after an exit from the SET-UP   state.   While in the INOPERATIVE state the CD should continuously run a self test to establish if   the device is still inoperative or if the device has been configured to allow it to operate.   fuel dispenser

we are committed to create the best workplace, encourage our staffs to put their own personalities into their jobs, and provide them a stage to show themselves.

    position to any kind of change. As Mr Blanchard says, there is a conflict between workers who value security and the economy as a whole, which needs flexibility. But this conflict does not have to be damaging, and is not all that hard to resolve. In essence, the point is to protect workers, rather tha fuel dispenser n jobs. This is what successful European countries do, such as Denmark or the Netherlands (which by OECD measures have lower unemployment rates than America). It does not imply the dismantling of the welfare state, which is why Europe s economic problems are not quite as ruinously insoluble as they sometimes seem. When privilege looks precarious But in big continental countries, the power of “insiders�is making this solution harder to adopt. Insiders—people with jobs in the public sector, or with secure private-sector employment—see economic reform not as a particular set of proposals, to be judged on its merits, but as the thin end of a wedge that threatens their whole privileged st fuel dispenser atus. To them, the possible gains from change are worth less than the risk of losing what they already have—the definition of risk aversion. This makes current insiders determined to reject reform almost across the board, and provides those who hope to be insiders in future—like French students—with an incentive to support the system as it is, rather than change it. Theirs is a logical choice. But as a result, large continental economies are becoming locked into opposing small changes which might benefit people and which they might even support in the abstract. Risk does not go away because you are averse to it; trying to make yourself invulnerable to small risks can end up leaving you more vulnerable to larger ones. You can, to a considerable extent, insulate some, even many, people from the risk of losing jobs, or being forced to work more than 35 hours a week, and so on. But you leave the country as a whole more open to other, more dangerous risks creating fewer jobs, creating an undercl fuel dispenser